24/7 on call

The questions to ask a heat pump installer focus on how they will design, install and support your system. Ask how they calculate the heat demand and required flow temperature, why they recommend a particular size and type, how they handle noise and permits, which costs the quote includes, how they support subsidy applications, what warranty and maintenance they offer, and how they will fine-tune the system after installation. Good answers are specific to your house and backed by calculations, not general promises. Comparing two or three installers using the same questions makes quotes easier to compare.

About the design

  • How will you calculate the heat demand of my house?
  • What flow temperature do you expect, and do any radiators need upgrading?
  • Why this size and type of heat pump?
  • How will hot water be produced, and at what temperature?
  • Will the system need a buffer tank, and why?

About installation

  • Where will the outdoor unit go, and is a noise assessment included?
  • Who handles permits and the notification to the municipality?
  • What happens to the old boiler and oil tank?
  • What electrical work is needed?
  • How long will the heating be off during installation?

About costs and subsidies

Question Why it matters
What exactly does the quote include? Removal, electrics, permits, balancing
What is excluded? Avoid surprises later
Do you help with subsidy applications? Applications must be made before work starts
What running costs do you expect? Shows whether the design has been thought through

The cost side is explained in heat pump cost in Switzerland.

About quality and after-sales

  • What warranty applies to the unit and the installation?
  • Do you offer maintenance, and what does it include?
  • Who holds the refrigerant authorisation for work on the circuit?
  • Will you adjust the system after the first winter?
  • Can I see references from similar houses?

Red flags

  • Sizing based only on the old boiler’s output.
  • No mention of flow temperature or radiators.
  • No noise assessment for an air-source unit.
  • Pressure to sign quickly.
  • Vague quotes with many exclusions.

Comparing quotes

Put the answers side by side. A slightly higher price for a properly calculated, well-documented system with good support is often better value than a low price with unclear scope. Check that all quotes cover the same work.

After installation

Ask for a handover with an explanation of the controls, settings and maintenance tasks. Keep the commissioning report. A follow-up after the first winter to adjust the heating curve and check data is a sign of a good installer.

Local knowledge

An installer who knows the region understands local climates, from the lake to the valleys, municipal procedures and cantonal rules. Local presence also means faster service when something goes wrong.

Example: owner in Ascona

An owner receives three quotes. One installer sizes the heat pump from the old boiler’s output and offers no noise assessment. The other two calculate the heat demand and propose upgrading one radiator. One of them also includes subsidy support, balancing and a follow-up after the first winter. The owner chooses this quote, even though it is not the cheapest.

About the controls

  • How will the heating curve be set initially?
  • Can I see operating data such as run hours, starts and backup heater use?
  • Is remote access available, and who can use it?
  • How are the hot water temperatures and hygiene settings defined for my system?

An installer who explains the controls clearly is more likely to set them up well. Good controls and transparent data make it easier to keep the system efficient over the years.

Meters and monitoring

Ask whether the system will have an electricity meter and a heat meter. With both, you can calculate the real seasonal efficiency and spot problems early. Some subsidy programmes or quality labels require such measurement. Even where it is optional, it is worth the modest additional cost.

Common mistakes

  • Choosing by price alone.
  • Not asking about flow temperature.
  • Ignoring after-sales service.
  • Signing before subsidies are approved.

Frequently asked questions

How many quotes should I get?

Two or three are usually enough to compare approaches and prices.

Should the installer visit the house?

Yes, a reliable design requires a site visit.

What documents should I receive?

Quote, design data, commissioning report, manuals and warranty documents.

Your heat pump installer in Ticino

AcquaKlima Sagl designs, installs and maintains heat pumps across Ticino, with clear quotes and follow-up after the first winter. Learn more about heating and heat pumps or get in touch.

From the blog

Need a quote or a call-out?

Call us or message us on WhatsApp: we reply in Italian, French, German and English.