24/7 on call

To shock a pool means adding a high dose of oxidiser, usually chlorine, to destroy contaminants that normal sanitiser levels can no longer keep up with. It may be needed when the water turns cloudy or green or smells strongly of chlorine, but these signs alone do not prove a lack of free chlorine: test first. Typical occasions are high combined chlorine, after heavy use or a big storm, and when reopening the pool in spring. The basic method: test the water, balance alkalinity and pH, clean the pool, add the shock product in the evening following the label, run the pump continuously, and keep swimmers out until the levels are back in the normal range. Handle the products carefully and never mix different chemicals.

What shock treatment actually does

Chlorine in the water reacts with sweat, sunscreen, leaves, pollen and bacteria. As it does, part of the free chlorine turns into combined chlorine (chloramines), which disinfects poorly and causes the typical “chlorine smell” and irritated eyes. A shock dose pushes the free chlorine so high that these compounds are broken down and algae are killed. Afterwards, the level falls back and normal dosing resumes.

Signs your pool needs a shock

  • Water turning cloudy, dull or greenish.
  • Slippery walls or visible algae.
  • A strong chlorine smell despite low free chlorine readings.
  • After a pool party or heavy use.
  • After a summer storm that washed in leaves, soil or pollen.
  • When the pool is reopened after winter.

Step by step

  1. Test before dosing: assess pH, alkalinity, free and combined chlorine and, if used, stabiliser. Correct alkalinity when needed, then pH.
  2. Clean: empty baskets, brush walls and floor, remove debris.
  3. Check the filter: backwash or clean if the pressure is high.
  4. Dose in the evening: sunlight breaks down chlorine quickly. Follow the product label for the amount relative to your pool volume.
  5. Distribute evenly: pre-dissolve granules only if the label says so (do not dilute products whose label does not allow it), add with the pump running, never directly into the skimmer unless the product allows it.
  6. Run the pump continuously for at least a day.
  7. Brush again the next morning.
  8. Test again: swim only when the sanitiser level is back within the recommended range.

Choosing a shock product

Type Notes
Fast-dissolving chlorine granules Common, effective; may affect pH; follow the label
Liquid chlorine Easy to dose, no residue; shorter shelf life
Non-chlorine oxidiser Breaks down combined chlorine; does not kill algae as effectively

The right choice depends on your treatment system. Some pools use salt electrolysis or other sanitisers, which have their own boost functions or compatible products. Ask your supplier or technician.

Safety first

  • Store chemicals in a cool, dry, ventilated place, out of reach of children.
  • Never mix different chemicals, especially chlorine with acid products.
  • Always add chemicals to water, never water to chemicals.
  • Wear gloves and eye protection.
  • Keep the original packaging and labels.

Green pool: a bigger job

A pool that has turned fully green often needs more than one shock, but do not repeat shocks without a diagnosis: check stabiliser, doses and the filter first, and make sure any flocculant is compatible with your filter and other products. Expect several days of continuous filtration, repeated brushing, frequent backwashing and sometimes a flocculant to settle fine particles before vacuuming to waste. If the water has been neglected for weeks, a partial water change may be faster. Before draining, check the rules for discharge in Ticino.

How to avoid frequent shocks

If you need to shock every week, something in the routine is off. Common causes are a pH that keeps drifting, too few filtration hours, a dirty filter or a sanitiser level that drops too low on hot days. The weekly and monthly tasks in our pool maintenance checklist address all of these.

Example: pool after a storm in Gordola

A summer thunderstorm washes leaves and soil into the pool, and two days later the water is dull green. The pool service brushes, empties the baskets, backwashes, corrects the pH and doses a shock in the evening with continuous filtration. After two days of brushing and a second backwash, the water is clear again and normal dosing resumes.

Common mistakes

  • Shocking without correcting pH first.
  • Dosing in strong midday sun.
  • Switching off the pump too early.
  • Swimming before levels return to normal.
  • Mixing products in the same container.

Frequently asked questions

How soon can I swim after shocking?

Only when the sanitiser level is back in the normal range. Test before swimming.

Can I shock a salt pool?

Yes, many salt systems have a boost mode, or a compatible product can be used. Follow the manufacturer’s instructions.

Does shocking fix cloudy water?

Often, but cloudiness can also come from poor filtration or water balance. Check the filter and pH too.

Professional pool care

AcquaKlima Sagl treats green and cloudy pools and provides regular maintenance across Ticino. Learn more about pool maintenance or get in touch.

From the blog

Need a quote or a call-out?

Call us or message us on WhatsApp: we reply in Italian, French, German and English.