24/7 on call

Heat pump maintenance is simpler than for oil or gas boilers, with no burner, flue or combustion check, but regular care still keeps the system efficient and reliable. Owners can keep the outdoor unit clear of leaves and snow, check the system pressure, clean accessible filters and watch for error messages. The annual professional service covers cleaning of the outdoor coil, checking operating data and settings, testing safety devices, inspecting electrical connections and hydraulic components, and, where required, leak checks on the refrigerant circuit. Work on the refrigerant circuit may only be done by authorised professionals.

Owner tasks

Task How often
Clear leaves, snow and debris from the outdoor unit As needed, especially autumn and winter
Check system pressure on the gauge Monthly during heating season
Clean accessible dirt filters or strainers (if the manual allows) As recommended
Check the display for error messages Regularly
Note electricity and heat meter readings Monthly or yearly

The annual professional service

  • Cleaning of the outdoor coil and fan.
  • Check of condensate and defrost water drainage.
  • Reading and analysing operating data: compressor starts, run hours, backup heater use.
  • Checking settings: heating curve, hot water temperature, hygiene programme.
  • Testing safety devices and electrical connections.
  • Checking expansion vessel, pumps, valves and system pressure.
  • Refrigerant circuit: visual check, leak check where required by law.

Refrigerant rules

Swiss rules on refrigerants require periodic leak checks for systems above certain refrigerant quantities and specify who may work on refrigerant circuits. The work must be done by individuals holding a special authorisation, or under their supervision. Your service company should keep the required records. More information is available from the Federal Office for the Environment.

Reading the operating data

Most heat pumps store useful data. A high number of compressor starts relative to run hours suggests short cycling. Many backup heater hours point to undersizing or wrong settings. Comparing electricity and heat meter readings shows the system’s real efficiency. A good technician uses this data to optimise the system, not just to tick boxes.

Signs something is wrong

  • Higher electricity use than in previous years.
  • Rooms not reaching the set temperature.
  • Frequent defrost cycles or ice building up on the outdoor unit.
  • Unusual noises from the compressor or fan.
  • Repeated error messages.
  • Falling system pressure.

Cold weather considerations

Winter is when heat pumps work hardest. Clear snow from the outdoor unit and make sure defrost water drains freely. See heat pumps in cold weather for details.

Maintenance plans

A maintenance plan schedules the annual service, keeps records and may include priority response, as set out in the contract. For homes with both a heat pump and air conditioning, one plan can cover both. See what an HVAC maintenance plan includes.

Warranty

Many manufacturers require documented regular maintenance to keep the warranty valid. Keep all service reports.

Example: house in Tenero

At the annual service, the technician notices from the data that the backup heater ran far more than expected. The cause is a setting that released the heater at too high an outdoor temperature. After the correction and cleaning of the outdoor coil, electricity consumption in the following winter is noticeably lower.

Hot water and hygiene settings

Most heat pumps also heat domestic hot water. The service should check the temperatures at the relevant points of the system and the hygiene settings. A periodic high-temperature cycle on its own does not make the water safe: temperatures, water renewal and operation must work together. Settings that are too low risk hygiene problems; settings that are too high waste energy, especially if the electric backup heater does the work. The technician finds the right balance for your household and documents it.

Keeping records

Write down the meter readings and any error messages between services. A simple notebook next to the heat pump or a photo of the display each month is enough. These records help the technician spot gradual changes, such as a slow drop in efficiency or a rise in backup heater use, that are easy to miss in a single visit.

Common mistakes

  • Assuming heat pumps need no maintenance.
  • Covering the outdoor unit in winter.
  • Ignoring rising electricity use.
  • Letting unauthorised people work on the refrigerant circuit.

Regular maintenance helps keep a system efficient and reliable and catches problems early, but it does not guarantee freedom from breakdowns, a fixed lifespan or passing official checks. Frequency and tasks depend on the system, its use, the manufacturer and legal obligations. Coverage, priority and response times are those set out in the contract.

Frequently asked questions

How often should a heat pump be serviced?

Typically once a year, plus any legally required leak checks.

Can I clean the outdoor unit myself?

You can remove leaves and debris; deeper cleaning of the coil is best left to the technician.

Does a heat pump need a combustion check?

No, there is no combustion.

Heat pump service in Ticino

AcquaKlima Sagl services heat pumps of all common brands across Ticino. Learn more about our maintenance plans or get in touch.

From the blog

Need a quote or a call-out?

Call us or message us on WhatsApp: we reply in Italian, French, German and English.